1, add oil to the generator (oil must be added to the right position, can not add more can add less motor is an oil scale, add oil to the scale), in addition to diesel, if it is water motor then add water.
2. Turn on the power transfer switch on the control panel of the diesel engine chassis or generator set.
3, use the key to start the diesel generator, check whether the electrical instrument or controller is normal, the machine has abnormal sound
4, see the diesel generator voltage, frequency is not your required value.
5. Carefully observe whether the working state lights, oil pressure and water temperature on the generator are normal and whether the unit has them
6. Before stopping, we must first unload all the load on the generator, then reduce the diesel generation speed to idle, and finally stop the generator
7, if the generator is used for a long time, we can not immediately sell to stop the generator after unloading the load of the generator, to let the generator run for a few minutes, so that the generator has enough cooling time if the generator is shut down for a long time, the battery power line should be disconnected from the generator, and in a period of time to start a generator set.
8, when the diesel generator temperature is below 5℃, we must add antifreeze or antifreeze oil in the water, if the temperature is below -10℃, we can not add water when adding water, directly add antifreeze.
9. When the generator has just stopped, you must not open the water tank immediately, otherwise the water that has not been completely cooled will eject and cause burns
10, the unit and other electrical equipment generally have packing boxes, in the handling should pay attention to the lifting of the cable ligation in the appropriate part of the machine, light light.
11, in order to install and lift the unit, first connect the prominent lifting point on the bottom frame, and then check whether it has been firmly hung, welding there are no cracks, whether the bolt tightening.
12. Once the machine is off the ground, use a guide wire to prevent the rope from kinking or the machine from swinging. The unit should be placed in a place where the tank can bear the weight of the generator.
13, if lifting the generator, should be installed a single point, suspension device standard has a day cover of the machine has a single point suspension device. When the unit is transported to the destination, if it needs to be stored, it should be placed in the warehouse.
If there is no warehouse to be stored in the open, the box should be padded high to prevent rain erosion, and the box should be covered with awning cloth to prevent the sun and rain from damaging the equipment.
Post time: Jan-31-2023