Check the cause of automatic stop when the oil is insufficient?

Why does the machine stop automatically when the oil is insufficient?

When the oil is insufficient, the oil warning switch inside the engine will ground the primary coil of the ignition coil, so that the ignition coil can not ignite, the engine flares out. The method to check whether the oil level is standard: put the engine in a horizontal position, unscrew the oil gauge, clean and dry, and then insert the oil inlet (no need to rotate), and then pull out, check that the oil level is above the middle of the oil gauge.

What must be done when the automatic Voltage regulator (AVR) is damaged and needs to be replaced?

The generator set does not generate electricity. The most common fault is the damage of the automatic voltage regulator. Therefore, some people often replace the old AVR with a new AVR when they find that the generator set does not generate electricity. When users did this, they found that the new AVR didn’t work after a few minutes, and then complained about the quality of the AVR. In fact, AVR damage is often caused by the user’s overload using the generator set, resulting in short circuit of the rotor, resulting in AVR damage, so before replacing the AVR must first test whether the resistance of the rotor is normal (such as the resistance of EC2500CX is 45-50 ohm). If the electrical set of the rotor is abnormal, replace the rotor before replacing the AVR.

1. Drain the gas tank and carburetor.

2. Drain the oil in the crankcase.

3. Fill the new oil to the upper oil level of the oil gauge.

4. Close the choke and pull the starter handle to where resistance is felt.

5. Wipe the unit clean and cover it with a carton or plastic cover to prevent dust.